Military Locker / Police Locker for Turnout Gear  

The Right Locker for the Right Job

The key to any turnout locker is the ability to grab and go when the call comes in. Our heavy duty TA-50 turnout lockers are popular as military lockers or police lockers and are also the answer for fire fighters, hazmat, ems or flight preparedness personnel that need quick access to their gear at a moment's notice. Protective equipment used by many emergency responder personnel needs to be ready for deployment at all times and proper storage cannot only make a difference in how long it lasts but also how well it protects personnel.

The open front turnout locker enables readiness by allowing PPE to hang freely in the open body of the locker while still providing seating and lockable bulk storage in the foot locker. As a flight locker, our turnout locker provides ample space for a helmet and other items on the upper shelf. The hanging area underneath can be outfitted with an optional heavy duty parachute rack or additional 7/8" wide wall hooks that can accommodate flight harnesses or survival vests. Multiple available locker accessories let you design your turnout locker with as much or as little as you need. And if you're struggling with limited space in a room, the turnout models can be fitted with a center divider and two coat rods to accommodate two users per locker.

This unit includes (as pictured)

• Heavy Duty Lockers: All locker body components made of cold rolled steel specially formed for added strength and rigidity and to ensure tight joints at fastening points
• Foot Locker: The reinforced lid of the foot locker features a continuous hinge and also serves as a seat. The front panel includes a single point latch with padlock strike plate and mini louvers for security and ventilation
• Locker Body: Sides, Bottoms, Tops, and Shelves: 16-gauge steel. Sides punched for shelf locations on nominal 12 inch centers
• Backs: Solid 18-gauge steel
• Sides: 16-gauge sheet steel with 3/4" (19mm) wide by 1-1/2" (38mm) high diamond-shaped perforations. Optional: solid sides without ventilation
• Tops and Bottoms: Three sides formed 90 degrees, the front offset formed to be flush with horizontal frame member
• Frame: Vertical frame member to be not less than 16-gauge formed to a channel shape and hemmed to create a smooth interior edge. Intermembering parts to be mortised and tenoned and electrically welded together in a rigid assembly capable of resisting strains. Hole spacing in locker body construction does not exceed 9" (225 mm)
• Assembly Hardware: Zinc plated truss fin head bolts and hex nuts; optional factory assembly of locker bodies using rivets
• Interior Equipment Shelf: 16-gauge full width located approximately 12" (304.8 mm) below top of locker
• Hooks and Coat Rod: Two heavy duty 3" high x 7/8" wide x 2-1/2" deep single-prong wall hooks and one chrome plated 1" diameter coat rod
• Powder Coat: Dry thickness: 1 to 1.2 mils (0.025 to 0.03 mm)
• Color: 21 color choices; call for two-tone paint